FairbanksGrandberry263

Clear the Location

You need to remove every little thing you can from the floor area you are going to refinish. Sofas, curtains, tables, rugs, etc. Another, usually overlooked, essential thing is to block as significantly of the airflo...

Regardless of whether you have just identified a hardwood floor beneath your old carpeting or the wood floor you installed is searching a little beat, refinishing is the best selection to bring out it's inner beauty. Here are the measures you need to have to take to refinish your floors on your personal.

Clear the Region

You require to take away almost everything you can from the floor location you are going to refinish. Sofas, curtains, tables, rugs, and so forth. An additional, usually overlooked, crucial point is to block as significantly of the airflow by means of the area as attainable. Whilst your finish is drying any airborne particles will stick and turn into element of the floor. Anything left in the area or these surrounding it should be effectively protected even though sanding. Dust covers and plastic blocking doorways are two of the greatest ways to accomplish this.

Before Sanding

You want to go more than your floor and fill in any cracks or gaps in the wood. Use wood putty in visible regions and caulk along the baseline if needed. If your floor was beneath carpeting, use diagonal pliers to remove any left over staples or remaining carpet padding. Then go around and sink any nails that might be sticking out as these can damage the sanding gear.

Floor Sanding

You want to wear a dust mask and ear protection, sanding your floor may well the noisiest, dustiest factor you ever do! You want to start off your sander above the floor and gently lower it down. Be careful not to gouge your floor, it isn't hard to do. Just remember to be gentle and let the sander sort of float along the surface of the wood. Also make sure you by no means let the sander sit in a single spot on your floor, it will leave a swirl mark in seconds that will take you hours to get rid of.

Sand with the grain of the wood. Move forward and backward more than every row so you get a good even sanding. The very first pass is your rough pass, now you need to have to alter to a medium grit paper and go over the complete region a second time. Then go more than the floor once again hunting for cracks, gaps and nails. Use putty and sink any nail heads you see.

Now you want to use a palm sander with a fine grit paper for your final sanding pass. When finished, vacuum the entire area like the walls and ceiling. You want to get rid of all particles, dust, and anything else that can stick in the you wood finish. Now it's time to buff. Stick to the grain in the wood and commence in the middle of the room. After that your wood floor is ready to be stained, that is it.B & G Hardwood Flooring 3727 Primrose Ave Santa Rosa, CA 95407 (707) 585-6829 http://bghardwoodflooring.net hardwood flooring in santa rosa