FortnerChewning553

Clear the Region

You require to get rid of almost everything you can from the floor region you are going to refinish. Sofas, curtains, tables, rugs, etc. Yet another, frequently overlooked, important factor is to block as much of the airflo...

Whether or not you've just identified a hardwood floor beneath your old carpeting or the wood floor you installed is seeking a little beat, refinishing is the very best selection to bring out it really is inner beauty. Here are the steps you want to take to refinish your floors on your personal.

Clear the Location

You want to eliminate every thing you can from the floor region you are going to refinish. Sofas, curtains, tables, rugs, and so on. Another, frequently overlooked, critical factor is to block as significantly of the airflow via the area as possible. Whilst your finish is drying any airborne particles will stick and turn into part of the floor. Something left in the area or these surrounding it should be properly protected even though sanding. Dust covers and plastic blocking doorways are two of the ideal ways to achieve this.

Before Sanding

You want to go more than your floor and fill in any cracks or gaps in the wood. Use wood putty in visible locations and caulk along the baseline if necessary. If your floor was beneath carpeting, use diagonal pliers to remove any left more than staples or remaining carpet padding. Then go about and sink any nails that may possibly be sticking out as these can harm the sanding equipment.

Floor Sanding

You need to have to wear a dust mask and ear protection, sanding your floor might the noisiest, dustiest point you ever do! You want to start your sander above the floor and gently reduced it down. Be careful not to gouge your floor, it isn't challenging to do. Just bear in mind to be gentle and let the sander sort of float along the surface of the wood. Also make positive you never let the sander sit in one spot on your floor, it will leave a swirl mark in seconds that will take you hours to take away.

Sand with the grain of the wood. Move forward and backward over every single row so you get a good even sanding. The very first pass is your rough pass, now you want to modify to a medium grit paper and go more than the entire region a second time. Then go over the floor once more hunting for cracks, gaps and nails. Use putty and sink any nail heads you see.

Now you want to use a palm sander with a fine grit paper for your final sanding pass. After finished, vacuum the whole region such as the walls and ceiling. You need to remove all particles, dust, and anything else that can stick in the you wood finish. Now it really is time to buff. Stick to the grain in the wood and commence in the middle of the space. Following that your wood floor is prepared to be stained, that is it.B & G Hardwood Flooring 3727 Primrose Ave Santa Rosa, CA 95407 (707) 585-6829 http://bghardwoodflooring.net hardwood flooring santa rosa